CLAS OC 0039 Руководство - Страница 6

Просмотреть онлайн или скачать pdf Руководство для Инструменты CLAS OC 0039. CLAS OC 0039 12 страниц. Tool to hold the cylinder hood/hatchback

OC 0039

TOOL TO HOLD THE CYLINDER HOOD/HATCHBACK

INTRODUCTION

It is compulsory to read this instruction manual before starting any kind of action.

The proper operation and full compliance of this product's performance is guaranteed only if all

the instructions provided in this manual are closely adhered to.

We guarantee that this product complies with the technical specifications described in this manual.

The manufacturer shall not be held responsible for any improper uses other than those described

herein.

Misuse:

• This product should only be used as described in this documentation; any other use is considered

improper.

• The manufacturer accepts no responsibility for any damage caused by the incorrect or

unreasonable use of the equipment.

• Moreover, misuse shall also void the warranty.

Take care of your tools:

• Be sure to store your tools in a clean state.

• Place the tools inside their original package.

SAFETY PRECAUTIONS

Carefully read all instructions, warnings and precautions.

During system operation, observe all safety regulations to avoid injury or equipment damage. In

case of doubt regarding safety or applications, contact Clas. Failure to observe these precautions

could result in serious equipment damage and personal injury.

PRECAUTION : indicates correct operating or maintenance procedures to avoid damage to the

equipment or to the surrounding environment:

• Check the correct operation of the tool and its integrity before use,

• Clean any dirt on the strut shaft, opposite to the one to be replaced, and on which to fix the

clamp,

• If it is used to replace bonnet struts, wait until the engine is completely cold.

WARNING : indicates a potential hazard that requires putting into practice the correct procedures

to avoid accidents:

• When replacing bonnet struts, always wear personal protective equipment (gloves, safety

goggles with side shields, safety shoes and work clothing).