Nikon COOLPIX 995 Инструкции
Просмотреть онлайн или скачать pdf Инструкции для Аксессуары для фотоаппаратов Nikon COOLPIX 995. Nikon COOLPIX 995 2 страницы. Quick ceph systems
Также для Nikon COOLPIX 995: Руководство по программному обеспечению (7 страниц), Помощь (2 страниц)
Печатать страницу
Nikon 995 Instructions for OneShot360
Recommended Camera Settings for OneShot360
•
When turning the CoolPix995 on, put it in M mode by turning the power dial two clicks
over from the OFF position.
•
Set the Image Quality to Fine by holding down the "QUAL" button until you see it change
from "NORMAL" to "FINE". This is the Fine setting.
•
Use the Zoom to exactly fill the digital camera LCD viewer screen with the circular image.
If you zoom in too much, you will lose part of the field of view. If you zoom in too little, you
will not get maximum resolution. Note also that the OneShot image may not be exactly
centered in the LCD screen – this is normal.
•
Make sure the pop-up flash is in its "down" position and the "flash disabled" icon is
showing on the LCD screen.
•
For best focus, you can set the camera to Infinity Focus (mountains) for outdoor shots
covering a large space or to Macro Focus (flowers) for indoor shooting. Please note,
when using Macro, any dust or fingerprints on the OneShot 360 will show up clearly in
the final image to be careful in your handling of this lens.
•
Note: The button for placing the camera in manual focus mode is the same as that for
setting the timer. If you want to use both the timer and a manual focus setting, you must
enable the timer first by pressing the "m-focus" button until you see the timer icon in the
LCD, then hold the button down and dial in the focus distance. Pressing the "M-focus"
button again will set camera back to auto focus mode.
•
Set the camera to aperture priority ("A") mode. This is done by holding down the "MODE"
button and rotating the command dial until the letter "A" appears in the lower left hand
corner of the LCD screen.
•
Now select an aperture value, which is displayed in the lower middle portion of the color
LCD. Rotate the command dial to select the aperture. We recommend using an aperture
setting of f6.7.
Take care to watch the shutter speed when in aperture priority mode. If the light level is low, you
will need a tripod when the shutter speed is slower than 1/125sec. The shutter speed is displayed
on the bottom of the LCD panel between the "A" mode and the "F6.7" display.
By pressing the "MENU" button just above the color LCD screen, you will have access to a list of
additional camera settings. Use the Multi selector button to scroll through the menu and make
your selection for the following:
•
Set the white balance. Automatic setting is usually adequate.
•
Set the Metering to Matrix Metering, this gives the best results for OneShot360 images.
•
Set the Sharpness value to "Normal".