Nikon MD-15 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов Nikon MD-15. Nikon MD-15 18 страниц. Motor drive

ATTACHING THE MOTOR DRIVE

Mounting the MD-12 on your camera is simple; the unit has

been designed such that it can be attached or removed at any

time regardless of whether or not the camera is loaded with film.

Before attaching the MD-12, make sure that its power switch is

turned off. Then, position the motor drive on the camera's bot-

tom plate, its handgrip should be at the same end of the camera

as the film advance lever. Ensure that the raised ring around the

drive shaft is correctly seated inside the locating collar, coaxial

with the camera's film advance coupling. Then, fasten the mo-

tor drive's attachment screw, turning it clockwise by means of

the thumb wheels on either side. Simultaneous use of both fore

finger and thumb will speed up attachment. Make sure there is

no gap between the motor drive and the camera body; then

tighten the attachment screw firmly.

When the MD-12 is mounted on an FM camera (Serial No. be-

low 3,000,000) *, the camera's mode selector switch around the

shutter release button should be set to "M" (motor)—the red

line on the selector being aligned with the line on the camera

body. This is not necessary with FM cameras (Serial No. over

3,000,000)* or the FE, because the switchover from manual film

advance to motor drive operation is made electronically and

automatically when the motor drive is switched on. Then, turn

the motor drive's power switch to "ON." If the film has been

advanced prior to attaching the motor drive, the motor drive