CLASSÉ AUDIO P-100 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель CLASSÉ AUDIO P-100. CLASSÉ AUDIO P-100 11 страниц. Power amplifier

UNPACKING & SET-UP

Your CLASSÉ P-100 power amplifier is packed in high density, semi-rigid foam placed in a

special cardboard box. To remove the unit, open and spread all the top flaps of the box and by its

sides, lift out the entire unit and put it on a large flat surface. Remove the plastic wrap and inspect

the unit for any concealed damage. Apart from this owner's manual, please ensure the following has

also been included:

1) Detachable linecord.

2) Allen key for the top cover.

Please report any damage or missing parts to your dealer as soon as possible.

Place the P-100 at or near its final set-up position, allowing 8 inches at the rear for tightening

the speaker output connectors. For optimum sonic performance, we recommend the optional

REFERENCE A.C. LINECORD

The power transformer in the P-100 is located at the front-center of the unit. Ideally, a few

feet should separate this area from components which potentially could pick up hum. These include

preamplifiers, turntables, and interconnect cables. In terms of providing adequate airspace for

cooling, a good rule of thumb is to allow 6 inches above and 3 inches on each side of the unit.

Check the Serial Number sticker on the back of the unit for the correct operating voltage.

The P-100 has only one fuse, the rating of which should be as follows:

. Consult your dealer regarding this accessory.

LINE VOLTAGE

100 or 120 V.A.C.

220 or 240 V.A.C.

FUSE RATING

5 AMP SLOW BLOW

3 AMP SLOW BLOW

-4-

125 or 250 volts

250 volts

CLASSÉ