Dirty Hand Tools 101100 Руководство по эксплуатации - Страница 15
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос Dirty Hand Tools 101100. Dirty Hand Tools 101100 20 страниц. 2” diameter semi-trash pump 7hp/208cc engine
Печатать страницуMaintenance
SWITCH OF THE ENGINE TO ITS "OFF" POSITION.
AIR FILTER
COVER
Changing /Cleaning the Air Filter
1. Remove the air filter by unloosening the wing nut on top of
Spark Plug Maintenance:
1. Disconnect spark plug wire from the end of plug. Clean out
SPARK
PLUG WIRE
2. Using a spark plug wrench, remove the spark plug. If the spark
3. When installing a new spark plug, adjust the plug's gap to the
4. Install the new spark plug or the cleaned spark plug into the
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL STARTING TURN THE POWER
Wait for the engine to cool, and remove the spark plug wire
before performing any inspection, maintenance, or cleaning
the cover then removing the wing nut on the filter. Pull the
filter straight up and check for dirt. Clean or replace the filter
element as needed. To clean wash the element in warm water
and mild detergent several times. Rinse and allow to dry. Soak
the filter in lightweight oil briefly, then shake out the excess.
Install the new or clean filter and secure the air cleaner cover.
debris from around the spark plug.
plug is oily, clean it with a dry rag. If the electrode has deposits
on it, polish it using emery paper. If the white insulator is
cracked or chipped, replace the spark plug.
specification on the technical specification chart. Do not pry
against the electrode or the insulator, the spark plug can be
damaged.
engine. Gasket style spark plugs should be finger-tightened
until the gasket contacts the cylinder head, then turned about
1/2 to 2/3 more rotation. Non-gasket-style spark plugs should
be finger-tightened until the plug contacts the head, then
about 1/16 turn more.
!
WARNING
procedures.
15