Dirty Pro Tools A388 ELBL Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Воздуходувка Dirty Pro Tools A388 ELBL. Dirty Pro Tools A388 ELBL 10 страниц. Electric

Emptying the debris bag

Empty the debris bag in good time. With a nearly full bag, the suction power drops notably. Organic

waste should be composted.

Switch off the equipment and pull out the power plug.

Open the zipper on the debris bag and shake out the material.

Close the zip on the debris bag again.

Cleaning & maintenance

Always pull out the mains power plug before starting any cleaning work.

Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe

the equipment with a clean cloth or blow it with compressed air at low pressure.

We recommend that you clean the device immediately each time you have finished using it.

Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or

solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into

the device.

After shaking out the debris bag, turn it inside out and thoroughly clean it in order to prevent mould

and unpleasant doors from forming.

You can use soap and water to clean out a heavily soiled debris bag.

Rub a bar of dry soap across the zipper teeth if the zipper becomes difficult to pull.

Clean the vacuum/blower tube with a brush upon evidence of dirt and grime.

Dirt and grime can make the switch (blower/vacuum) more difficult to operate as a result of the

material that swirls up off the ground. When this occurs, simply flip the switch back and forth a few

times, which should bring it back to the normal feel.

Troubleshooting guide

Fault - Motor does not start

Possible cause - No voltage present / Power cord defective

Remedy - Check the cord and fuses / Check the power cord