Armstrong Air RP14HP Series Руководство по установке и обслуживанию - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Кондиционер Armstrong Air RP14HP Series. Armstrong Air RP14HP Series 13 страниц.

Duct System

Duct system should be designed and sized according to the
methods in Manual Q of the Air Conditioning Contractors of
America (ACCA).
A closed return duct system shall be used. This shall not
preclude use of economizers or outdoor fresh air intake. It
is recommended that supply and return duct connections
at the unit be made with flexible joints.
The supply and return air duct systems should be designed
for the CFM and static requirements of the job. They
should not be sized to match the dimensions of the
duct connections on the unit.
The unit is shipped ready for horizontal flow (side duct
connections). Before attaching side ducts, bend perforated
duct tabs out to assist with duct alignment and attachment.
Duct attachment screws are intended to go into the duct
panel. Duct to unit connections must be sealed and
weather proofed.
If downflow duct system is desired, a downflow conversion
kit is required, and the following conversion is required.
1.
Using a knife, cut following the marked cut lines on
the unit base insulation to access bottom metal covers
underneath the insulation.
2.
Remove the screws securing the bottom covers and
discard the bottom covers (supply and return).
3.
Remove screws located between the supply and return
openings that attach the blower deck to the base, and
discard these screws. These screws can interfere with
bottom duct connections or roof curb seals.
4.
Secure side duct covers provided in the downflow
conversion kit over the side duct openings (use
dimples on back panel to locate cover attachments).
5.
Install drain pan overflow switch and wire according to
downflow conversion kit instructions.
Air filters are not supplied with the unit. A field-provided air
filter must always be installed ahead of the evaporator coil
and must be kept clean or replaced. Dirty filters will reduce
the airflow of the unit.
An optional filter rack kit may be purchased separately
for installation inside the unit's coil compartment. Air filter
sizes are shown in Table 2 for use with filter rack kit.
507296-01

Filters

The filter rack must be installed prior to installation of
the unit in applications where access to the rear panel
is limited.
Unit Model
24,30,36
42,48,60
Table 2. Unit Air Filter Sizes - inches
This package unit is equipped with a 3/4" FPT coupling
for condensate line connection. Plumbing must conform
to local codes. Use a sealing compound on male pipe
threads.
Do not operate unit without a drain trap. The condensate
drain is on the negative pressure side of the blower;
therefore, air being pulled through the condensate line will
prevent positive drainage without a proper trap.
The condensate drain line must be properly trapped,
routed to a suitable drain and primed prior to unit
commissioning.
NOTE: Install drain lines and trap so they do not block
service access to the unit.
See Figure 5 for proper drain arrangement. The drain line
must pitch to an open drain or pump to prevent clogging
of the line. Seal around the drain connection with suitable
material to prevent air leakage into the return air system.
To prime trap, pour several quarts of water into drain,
enough to fill drain trap and line.
Drain lines should be hand-tightened only. Do not use
tools to tighten fitting into drain.
Issue 1650
NOTE:
Filter 1
14 X 20
20 X 20

Condensate Drain

CAUTION
Filter 2
20 X 20
20 X 20
Page 5 of 13