Cub Cadet 190-341-100 Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Снегоуборщик Cub Cadet 190-341-100. Cub Cadet 190-341-100 20 страниц. 42" snow thrower attachment for cub cadet series 2000/2500 tractors
Также для Cub Cadet 190-341-100: Руководство по установке и обслуживанию (20 страниц)
Печатать страницу
Assembly & Set-Up
Snow Thrower Assembly Preparation
WARNING!
snow thrower assembly, select a firm and level
surface that is large enough to accommodate both
the snow thrower attachment and tractor. Engage
the tractor parking brake.
1.
Cut the cable tie(s) securing the drive shaft to the snow
thrower sub-frame and carefully unfold the sub-frame arms
See Figure 4-1.
DRIVE
SHAFT
CABLE TIE
2.
Slide the front end of the drive shaft onto the input shaft of
the sprocket box assembly on the rear of the snow thrower.
Align the holes and secure with hex cap screw (10, Fig.3-2)
and hex insert lock nut (16, Fig.3-2). See Figure 4-2.
8
Before beginning preparation of the
SUBFRAME
ARMS
Figure 4-1
HEX CAP
SCREW
DRIVE SHAFT
HEX INSERT
LOCK NUT
SPROCKET BOX
Figure 4-2
3.
Install the chute crank support tube (B, Fig.3-1) onto the LH
upper link of the snow thrower (A, Fig.1) subframe using
the hex cap screw (7, Fig.3-2), hex cap screw (17, Fig.3-2) and
two hex flange lock nuts (13, Fig.3-2). Note: the longer hex
cap screw (17) must be installed in the rearward hole. Refer
to Figure 4-3.
HEX FLANGE
INSERT LOCK NUT
LH UPPER
LINK
HEX CAP SCREW
(1-1/2" LG.)
HEX CAP SCREW
(1-1/4" LG.)
Figure 4-3
4.
After making sure the chute crank rod is routed through
the eyebolt, insert the rod into the sleeve of the joint block
on the chute crank assembly. Align the holes and secure
the rod with the cotter pin (4, Fig.3-2). See Figures 4-3 and
4-4.
CHUTE CRANK
ASSEMBLY
JOINT
BLOCK
Figure 4-4
5.
Route the tilt handle cables along the inside of the upper
chute crank support tube and secure to the support tube
with two cable ties (11, Fig.3-2). See Figure 4-5. Cut excess
length from the cable ties.
4
JOINT BLOCK
CRANK ROD
EYEBOLT
CHUTE
CRANK
ROD
CHUTE CRANK
SUPPORT TUBE
COTTER PIN
CHUTE
CRANK
ROD