Cub Cadet 190-341-100 Руководство по установке и обслуживанию - Страница 9
Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Снегоуборщик Cub Cadet 190-341-100. Cub Cadet 190-341-100 20 страниц. 42" snow thrower attachment for cub cadet series 2000/2500 tractors
Также для Cub Cadet 190-341-100: Руководство по эксплуатации (20 страниц)
Печатать страницу
6. Route the tilt handle cables along the bend in the
lower end of the chute crank support tube and
secure to the support tube with a cable tie (11).
See Figure 8.
CHUTE CRANK
SUPPORT TUBE
CABLE TIES
TILT
HANDLE
CABLES
Figure 8
7. Route the tilt handle cables across the top of the
snow thrower lift shaft toward the right side of the
snow thrower. Loosely fasten the cables to the lift
shaft with a cable tie (11). Do not fully tighten the
cable tie. Refer to Figure 8.
8. Insert the lower end of the lift handle assembly (C,
Fig.1) into the lift bracket located on the right side
of the snow thrower subframe. See Figure 9.
LATCH
RELEASE
CABLE
LIFT
HANDLE
HEX FLANGE
LOCK NUT
LIFT INDEX
ROD HOLE
Figure 9
NOTE: The latch release cable may, or may not, have
been connected to the lift index rod at the factory. If
already connected, skip to Step 12. If not connected,
perform the following steps 9-11 to connect the cable.
9. Insert the bottom of the cable 'Z' end fitting through
the hole in the lift index rod. Refer to Figure 9.
10. If necessary, turn the jam nuts on the conduit fitting
11. Temporarily tighten the jam nuts against the upper
12. Align the holes of the lift handle and lift bracket,
13. Refer to Lift Latch Adjustment on Page 14 for
14. Route the latch release cable along the lift handle
LIFT SHAFT
LIFT BRKT.
SLOT
HEX CAP
SCREW
B. TRACTOR PREPARATION.
This section describes the steps necessary to pre-
pare the appropriate tractor models for installation of
the snow thrower attachment. Some instructions ap-
JAM NUT
ply only to specific production model years. The pro-
CONDUIT
duction models referred to will be noted in the
FITTING
heading for those instructions. Skip all instructions
CABLE 'Z'
that do not apply to your installation.
END FITTING
LIFT BRACKET
NOTE: The mower deck and its front lift rod, or any
other front mounted attachment must be removed from
the tractor.
9
to create a space between the nuts. With a jam nut
positioned both above and below the lift bracket,
slide the conduit fitting fully into the slot of the lift
bracket. Refer to Figure 9.
and lower surfaces of the lift bracket.
and secure with the two hex cap screws (6, Fig.2)
and hex flange lock nuts (13, Fig.2). Refer to
Figure 9.
instructions to adjust the cable.
and secure the cable to the handle using two tie
straps (11, Fig.2) as shown in Figure 10. Cut the
excess from the tie strap ends.
CABLE
TIE
Figure 10
WARNING:
If
the
recently operated, the muffler, exhaust
pipe, and surrounding areas will be HOT.
Allow the tractor to cool before begin-
ning preparation.
LATCH
RELEASE
CABLE
LIFT HANDLE
TRIGGER
ASSEMBLY
tractor
has
been