Cub Cadet 221 LHP Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Снегоуборщик Cub Cadet 221 LHP. Cub Cadet 221 LHP 20 страниц. Single stage snow thrower
Также для Cub Cadet 221 LHP: Брошюра и технические характеристики (2 страниц), Технические характеристики (2 страниц), Руководство по эксплуатации (20 страниц), Руководство по эксплуатации (20 страниц)
Печатать страницу
Installing the Chute
1.
Place the chute handle on the lower chute as shown in Fig.
3-3. Be certain that the handle is aligned in the channel on
the chute and the tabs snap into place.
2.
Remove the hex washer screws in the chute base. See Fig.
3-4.
Hex Washer
Screw
8
s
3— a
ectiOn
sseMbly
Channel
Tab
Figure 3-3
Figure 3-4
& s
-u
et
p
3.
Align the holes in the chute base with the holes in the
lower chute and secure with the previously removed hex
washer screws. See Fig. 3-5.
Figure 3-5
Installing the Recoil Starter Handle
1.
Remove the eye bolt and handle knob from the manual
bag.
2.
Place the eye bolt and handle knob on the upper handle as
shown in Fig. 3-6. Do not fully tighten the hardware until
instructed to do so.
Recoil Starter Handle
Eye Bolt
Handle
Knob
Figure 3-6
NOTE: The opening of the eye bolt should face toward the
back of the snow thrower.
3.
Slowly pull the recoil starter handle up towards the eye
bolt.
4.
Slip the recoil starter rope into the eye bolt from the back
side of the snow thrower. See Fig. 3-6.
5.
Securely tighten the eye bolt and handle knob.