Cub Cadet 317-262-100 Руководство пользователя - Страница 13
Просмотреть онлайн или скачать pdf Руководство пользователя для Снегоуборщик Cub Cadet 317-262-100. Cub Cadet 317-262-100 20 страниц.
Печатать страницу
8 .
q
4 .
start engine; engage and disengage auger clutch control to be sure that the auger
stops turning when the clutch control is released.
lf the auger does not stop turning when control is released, adjust the tension on the
clutch control cable following instructions on page 6.
Reinstall the belt cover and the enoine cover/cowlino.
1 0 .
REPLACING 1.
SHAVE
2.
PLATE
S E R V I C I N G 1 ,
SP A RK
2 .
P L U G
^
Remove key from ignition switch.
Remove the three screws and nuts
securing the shave plate to the
auger housing. Save the hardware.
S e e f i g u r e 1 1 .
Remove the worn blade.
Installthe new blade and secure it
with the three screws and nuts ear-
lier removed.
Remove key from the ignition switch.
Remove the engine cover following
i n s t r u c t i o n s
o n p a g e 1 1 .
Disconnect wire from the spark plug
and remove the plug. See figure 12A.
Inspect the plug and clean carbon
deposit from the electrodes with a
wire brush.
lf the plug is burned or pitted. replace it
with a new plug (part # 731-0732) as
recommended in the engine manual.
Adjust the gap between electrodes to
.030 inch using a wire feeler gauge.
See figure 128.
Install the plug and tighten it firmly.
Reconnect the plug wire.
8. Reinstall the engine cover/cowling. FIGURE 12A
Electrodes
.030 Gap
F I G U R E 1 2 8
F I G U R E 1 1
4 .
tr
S h a v e P l a t e B o l t s
t2