Armytek Prime C2 Руководство пользователя

Просмотреть онлайн или скачать pdf Руководство пользователя для Фонарик Armytek Prime C2. Armytek Prime C2 2 страницы. Prime series

Печатать страницу

Armytek Prime C2 Руководство пользователя

C2 only: With ambient temperature +25°C the flashlight delivers light in Maximum mode for about 6-10 minutes and then the

brightness decreases by 35%. After cooling-down (at sufficient voltage level) the brightness increases to the Maximum mode again.

This stepping goes cyclically to maintain the user's safety and the flashlight's functionality. In conditions of good air-cooling the

flashlight delivers light without stepping down even in Maximum mode. There are no preset timers for stepping, but real-time active

temperature measurements.

1. Always follow the instructions from this manual and recommendations on battery usage.

2. Apply only the recommended power sources.

3. Do not reverse battery polarity.

4. Do not use different power sources together, i.e. old ones with new ones, charged with

discharged. Do not use different types of batteries combined as the element with less

capacity can be damaged.

5. Do not modify or recast the flashlight and its components as it will deprive you of the

warranty.

6. Do not allow water or any other liquid to leak into the flashlight.

7. Do not aim a turned-on flashlight at people's or animals' eyes – it can cause temporary

blindness.

8. Do not allow children to use the flashlight without your assistance.

Armytek Optoelectronics Inc. shall not be liable for any harm done to the user if it

was caused by improper use of the product.

Care and Storage

It is recommended to clean the threads and O-rings off dirt and old grease. Remember that secure protection from water and dust

cannot be provided by worn out sealing. And fouling as well as lack of lubricant cause fast wear-out of threads and sealing rings.

To clean the threads do the following:

1. Unscrew the tailcap and remove the sealing ring carefully with a toothpick (do not use sharp metal things as they can damage the

ring).

2. Wipe the sealing ring thoroughly with a soft cloth (or tissue). Do not use solvents. If the sealing ring is worn out or damaged

replace it by a new one.

3. Clean the metal threads with a brush using ethanol. Be careful not to allow applied liquid to get inside the flashlight or tailcap as it

can cause fails in functionality of the flashlight.

After cleaning lubricate the thread and the sealing ring with polyalphaolefin-based silica grease, e.g. Nyogel 760G.The application of

automotive and other improper grease can cause swelling and damage of the sealing rings.

In case of active operation and exploitation in dusty environments, it is recommended to perform cleaning and lubricating of the parts

as often as required, even if it is more than twice a year.

Service and Warranty

Armytek provides free warranty repair for 10 years from the purchase.

Warranty doesn't cover damage caused by:

1. Improper usage.

2. Attempts to modify or repair the flashlight by nonqualified specialists.

3. Longtime application in chlorinated or polluted water, or other liquids (other than water).

4. High temperatures and chemicals' exposure (including the exposure of liquid from defected batteries).

5. Usage of low-quality batteries.

Armytek Optoelectronics Inc.

Web: www.armytek.com Email: [email protected]

Address: 67 Vandervoort Dr, Richmond Hill, Ontario, L4E 0C7, Canada

Specifications are subject to change without notice.

Warnings

Prime

THE MOST TECHNICALLY ADVANCED

FLASHLIGHTS IN THE WORLD

USER MANUAL

Thank you for choosing the products of Armytek Optoelectronics Inc., Canada.

Please read this manual carefully before using the flashlight.

Specifications

Armytek Optoelectronics Inc. is a Canadian manufacturer that produces powerful and reliable flashlights designed especially for your

needs applying in them components made in the USA and Japan.

Superb light of amazing constant brightness due to powerful electronics and active temperature control without timers

Efficient TIR-optics and no "tunnel vision" effect even after continuous use

Warning Indication of low battery level and high temperature

Side switch for comfortable one-hand operation and easy modes switching

Ultra low current drain in OFF-state - more than 25 years

Removable clip, comfortable holster and possibility of tail-stand for multipurpose use

Compact and light-weight flashlight of guaranteed durability stands up harsh impacts and falling from 10 meters

Total protection from water, dirt and dust penetration - flashlight continues to work even at the depth of 10 meters

Model

Prime A1

LED / Optics

Brightness stabilization type

Light output, LED / OTF lumens*

450 / 370

Peak beam intensity, candelas

3050

Hotspot/spill

Beam distance*

110 meters

Hotspot diameter at 100 meters

Firefly1: 0.15 lm / 90d

Modes and runtimes (measured for

Firefly2: 1.7 lm / 200h

Sanyo Eneloop AA 2000 mAh /

Main1: 10 lm / 25h

Armytek CR123A 1500 mAh / Armytek

Main2: 70 lm / 3h

18650 Li-Ion 3100 mAh to the

Main3: 210 lm / 1.2h

decrease to 10% of initial brightness)

Max: 370 lm / 30min

1xAA /

Power source

1x14500 Li-Ion

Length 103mm,

Size

body diameter 24.5mm

Weight (w/o batteries)

54g

* Light outputs for flashlights with Warm light are about 7% less, beam distances are about 3% less.

** C2: in Max mode stabilization is DIGITAL, in all other modes - FULL.

We recommend to use Sanyo Eneloop AA rechargeable batteries instead of ordinary AA batteries to obtain higher brightness

and longer runtimes. We highly recommend NOT to use CR123A batteries as a power source for often and continuous

flashlight's operation. Remember that old or low-quality disposal batteries can be damaged under heavy load and explode.

10 years no-hassle warranty

Prime A2

Prime C1

Prime C2

Cree XP-L / TIR

FULL stabilization (constant brightness)**

620 / 500

500 / 400

1200 / 1050

4250

3100

8800

20°/ 80°

130 meters

111 meters

188 meters

35 meters

Firefly1: 0.15 lm / 130d

Firefly1: 0.2 lm / 100d

Firefly2: 1.7 lm / 300h

Firefly2: 2 lm / 18d

Main1: 10 lm / 48h

Main1: 10 lm / 40h

Main1: 35 lm / 48h

Main2: 70 lm / 9.5h

Main2: 70 lm / 5h

Main2: 200 lm / 9h

Main3: 210 lm / 2.5h

Main3: 210 lm / 2h

Main3: 420 lm / 3.8h

Max: 500 lm / 1h

Max: 400 lm / 35min

Max: 1050 lm / 1.5h

1x18350 Li-Ion /

1x18650 Li-Ion /

2xAA

1xR123 Li-Ion/1xСR123A

2xCR123A/2xR123 Li-Ion

Length 149mm,

Length 87mm,

Length 118mm,

body diameter 24.5mm

58g

56g

52g