Discount Car Stereo AUX-HON03 Краткое руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Краткое руководство по установке для Автомобильная стереосистема Discount Car Stereo AUX-HON03. Discount Car Stereo AUX-HON03 4 страницы. Aux jack for honda/acura with sirius tuner or slave unit

Печатать страницу

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

•

This installation guide is provided as a GENERAL installation guide, some vehicles vary and

may require additional steps. We do not accept responsibility for third party labor charges

or modifications. Exercise due-diligence when installing this product.

•

We do not accept any responsibility for vehicle damage or personal injury resulting from

the installation of this product.

Careless installation and operation can result in equipment damage

•

Requirements:

Sirius Tuner module or slave player

Introduction

The AUX-HON03 auxiliary cable can be installed in any Honda-Acura vehicle with

a SiriusXM Tuner module (with or without subscription), external CD changer or

external cassette player. Users retain full use of the factory option plus the

ability to connect and play all kinds of audio devices including Smartphones, MP3

Players, iPods etc.

External CD player, CD changer, cassette player etc. required are not built into

the AM/FM radio, but rather installed in lower dash, armrest, trunk or hatch.

For more details, see Frequently Asked question section at the end of this

guide.

Installation

Remove radio to gain access to the connector. Vehicle specific radio removal

instructions are not part of this guide, but available upon request

Warning: Devices with 14-pin blue plug (See Fig. 1) are NOT compatible. The

AUX-HON03 applies to vehicles with 14-pin white plug as seen in Fig. 1

Honda 14-pin plugs

With radio removed, disconnect 14-pin plug (See Fig. 1) from radio

port (See Fig. 2)

Fig. 2

radio 14-pin port

2. Connect 14-pin plug removed in step1 harness 14-pin connector

3. Connect harness 14-pin plug to radio port vacated in step 1 (See Fig. 2)

4. Carefully route audio jack (See Fig. 3) to a location on the dash or

nearby panel where it will be mounted (within 3.5 ft.) This location will

vary based on vehicle and customer's preference

Fig. 1