BLADEZ PB-SE1803 Справочник - Страница 15

Просмотреть онлайн или скачать pdf Справочник для Скутер BLADEZ PB-SE1803. BLADEZ PB-SE1803 18 страниц. Gas powerboard powered personal transportation

Печатать страницу

ADJUSTING THE BELTS

The belts will come adjusted from the factory. However, it may be necessary to

adjust the pulleys from time to time. The belts must be well aligned onto the pulleys

otherwise they may start to rub and chafe, which will result in shortened belt life.

How tight should the belt be?

If the belt is skipping or jumping on the pulley teeth, this is to loose and

may be harmful.

If the belt is making a humming sound when the wheel it turning, this is to

tight and may cause the belt to snap.

The correct tension is achieved by adjusting the belt from its loose position

to when it becomes lightly tense.

To adjust the head unit:

1. Rotate the handle bar as far right as it

will go to expose the HEAD UNIT (Fig.

13).

2. Using a large adjustable wrench, gently

turn the BEARING LOCK clockwise to

tighten. * DO NOT OVER TIGHTEN OR

IT WILL DAMAGE THE BEARINGS

To tighten the belts:

1. Open the belt cover.

2. Rotate the rear wheel to assess the

alignment of the belts.

Adjust the small belt first.

3. Loosen the tensioned lock nut under the

clutch first.

4. Adjust the outer and inner adjuster

screws acutely together, by making

minor adjustments one at a time. (Fig.

14). After each adjustment rotate the

rear wheel to insure that the belt is

aligned.

Then adjust the large belt.

5. Slightly loosen the two Axle bolts on

both sides of the rear wheel. (Fig. 15).

Then slowly adjust the two adjusting

screws on each side of the rear tire (Fig.

16) until belt reached the proper tension.

Page 15 of 18