BLADEZ PB-SE801-26C Справочник по продукции - Страница 12

Просмотреть онлайн или скачать pdf Справочник по продукции для Скутер BLADEZ PB-SE801-26C. BLADEZ PB-SE801-26C 15 страниц. Gas powerboard

When the engine is idling, under no circumstances should your MOBY X

be moving.

If the MOBY X continues to move after idle speed adjustment, contact

Bladez or your local Bladez service center.

TIRES AND WHEELS

The Bladez MOBY X uses an identical rim and tires assembly on the front and rear

wheels, which means that the tires can be rotated. The wheels are actually two

wheel halves (split rim) bolted together to make it easier to remove and replace the

tire and tube.

The rear wheel is fitted with a special spacer to accommodate the rear sprocket,

while the front wheel has a bracket for the V-Brake.

Tire wear will differ based on rider weight, riding conditions and care. Replacement

tires can be obtained at your local Bladez dealer, through motorcycle shops, or from

the Bladez website at www.ebladez.com.

Tire Pressure

The tire must be inflated to a maximum of 50 P.S.I.. It is also recommended to

use a tube additive like Slime purchasable from any motorcycle shop, to avoid

inconvenient punctures.

Empty all air from the tire, prior to loosing the bolt to split the rim.

until the MOBY X starts to move

forward.

3. Then open (counter-clockwise) the

screw until the MOBY X stops.

4. You have reached the correct idle speed

when the engine runs smoothly below

the RPM when the MOBY X starts to

move.

Note: Standard idle RPM is about 2500-

3000 RPM.

Page 12 of 15