Discount Equipment SS-18 Руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Discount Equipment SS-18. Discount Equipment SS-18 9 страниц.
Печатать страницуE-SS-16/18-lE-2/98
OPERATING INSTRUCTIONS
Read and understand these instructions completely
before starting or using machine.
READ "Rx FOR CONCRETE SAWS" SAFETY INSTRUCTIONS BEFORE OPERATING
tN•JitHi
1. When loading or unloading the saw from or onto a trailer, on ramp or incline, use extreme caution and low soeed.
Blade must be raised high enough to clear all obstacles.
2.
This unit is shipped with oil but without gasoline. Check engine manual and follow manufacturers instructions on
break-in, servicing and use of engine.
3.
To "free wheel" - move Clutch Cam Lever (10) to the "DISENGAGED" position. This will release the drive
mechanism and the wheels will roll freely.
·
4.
Before starting - check to be sure that blade is raised - not in contact with slab surface and blade guards are in place.
Be sure you have selected the proper blade for the job and installed it properly on the arbor shaft.
5.
Front and rear guides are adjustable - align saw on cutting line, adjust both front and rear guides. Be sure cutting line
is well defined for operator to follow easily.
6. · Allow engine to warm up at half throttle before starting to cut.
7.
Cut at FULL throttle. DO NOT attempt to change governor setting - it is factory set for correct speed.
8.
This saw is designed to cut in a straight line. DO _NOT FORCE the saw or twist it back in line.
ENGINE STARTING:
•
BEFORE starting engine - read instructions supplied by engine manufacturer.
•
CHECK OIL LEVEL.
•
Be sure blade is clear of slab surface - move Clutch Cam Lever (10) to "Disengaged" position.
•
Familiarize yourself with all engine and saw controls. (See Figure 1)
MODELS WITH O UT ELECTRIC START ENGINES:
•
Locate engine controls: Throttle, Choke, Stop Button
•
Locate saw controls: Blade_ Lift Controls, Water Safety Switch, Drive Selector Lever ...
•
Place Water Safety Switch (6) in the "ENGINE START-DRY CUT' position or engine will not start.
•
Change position of the engine-mounted STOP switch to ON (if applicable; check engine manual).
•
Follow engine manufacturers instructions on proper starting.
•
Open throttle
Y.
to Y, ... allow engine to reach operating temperature ...
•
NOTE: ALL CUTTING IS DONE AT FULL THROTT/-E.
MODELS WITH ELECTRIC START:
•
Locate engine controls: Throttle, Choke, Ignition ON/OFF Switch
•
Locate saw controls: Blade Lift Controls, Water Safety Switch, Drive Selector Lever, ..
•
Place Water Safety Switch (6) in the "ENGINE START-DRY
cur·
position or engine will not start.
•
Follow engine manufacturers instructions on proper starting.
•
Momentarily change position of the Engine Ignition Switch (5) to START. After engine starts, leave Engine
Ignition Switch in the ON position.
•
Open throttle
Y.
to Y, ... _allow engine to reach operating temperature ...
•
NOTE: ALL CUTTING IS DONE AT FULL THROTTLE.
4