ARNOLD UA 500 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Приводы постоянного тока ARNOLD UA 500. ARNOLD UA 500 17 страниц. Universal drive

2. Preparation / Assembly / Commissioning

Before each use, the motor shall be checked for possible damages. Special attention

shall be paid to the tight fit of the upper and lower eyebolt. The firm screwing of the

two halves of the housing is also important. These are secured by means of a bolt,

which is located under the guarantee label. A damage of the security seal can

indicate an inadmissible opening or loosening of the halves of the housing.

For fastening the drive on a load rod in theaters or on other structural components

and on the load to be driven, there are two eyebolts at both ends of the drive. For this

purpose, you can use permitted slings such as round slings, shackles or chain links

which can be screwed. A chain link which can be screwed (NG 12) with a nominal

load capacity or WLL (Working Load Limit) of 750 kg with regard to a working

coefficient of 10 is part of the scope of supply of the UA 500. Smaller fastening

elements can also be used in compliance with the dimensioning regulations

according to DGUV directive 17.

See also dimensioning according to DIN 56950-1 "Entertainment Technology –

Machinery Installations – Part 1: Safety requirements and testing". The drive itself is

designed for a breaking load of more than 15 t and has demonstrably the 10-fold

safety required according to DGUV directive 17.

Please avoid greater asymmetrical load distributions! Otherwise too high lateral and

tensile forces can occur at the fastening elements!

The motor is only designed for a vertical load. After fastening and securing the drive,

the connection to the Motor-Controller is established. In order to avoid a danger due

to uncontrolled movements, the connection to the power supply may only be

established thereafter. Please observe that objects with large dimensions or surfaces

have considerable air resistances and already trigger the torque clutch of the UA 500

at low rotation speeds.

The kinetics of a large object can also cause very long acceleration and deceleration

phases. In case of doubt please contact us. We will be pleased to advise you with

regard to your planned application.

Page 2 of 11

12/2021 REV.19