3D Hobby Shop 70 AJ SLICK Руководство по сборке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушка 3D Hobby Shop 70 AJ SLICK. 3D Hobby Shop 70 AJ SLICK 19 страниц.

Before installing the elevator with the slot which accepts the joiner, practice fitting it once,

the joiner is very tight in the slot. Use plenty of polyurethane or epoxy glue in the slot, and

install the elevator. Make sure it can swing freely at least 45 degrees up and down. Allow

to dry.

Install elevator horn as shown, using the same technique as for the rudder horns. Remove

covering over the elevator servo opening, and install elevator servo, attached to an 18-24"

extension, as shown. Assemble pushrod and install, using black screws and locking nuts to

attach the ball joints to the servo arm and control horn.

NOTE: We recommend the use of one elevator servo with metal gears and at least 100

oz/in of torque. However, enough hardware is supplied in your kit to install a second

elevator servo, in "mirror image" fashion, on the other side of the fuselage. Note that this

may result in a tail-heavy condition unless you are using a large and heavy power system.