Aroma Professional ABD-700 Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Блендер Aroma Professional ABD-700. Aroma Professional ABD-700 8 страниц.

CLEANING AND CARE

To ensure the longevity of your Aroma Professional Blender, always make

sure to clean after each use. The blender can be cleaned easily with the

following steps:

Fill the Container up half way with clean water up to the 4 cup marker. For more thorough

cleaning, add two slices of lemon or a couple drops of detergent. Cover with the

Container Lid and secure the Lid Cap.

Set the Container firmly on the Base.

Set the Mode Switch to Timing and the Time switch to 35.

Turn the Power Knob clockwise to MAX.

Allow the machine to run until it stops automatically.

Remove the Container from the Base, remove the Container Lid, and rinse out the

Container thoroughly with clean water.

Dry the exterior of the Container and place it back on the Base.

Turn the Power Knob to MAX for three seconds to dry out the Bearings. Turn the blender

off, remove the Container, and allow it to air dry.

When cleaning the appliance,

do not soak the power axel

in water .

Fill the pitcher with clean

water and start the machine

to clean it .

•

For your safety, always make sure the Mode Switch and Power Switch are both

set to Off, and the Power Cord is unplugged before troubleshooting.

WARNING

My blender will not start.

Double check the power cord to make sure that it is properly plugged in. Press the circuit

breaker reset button located on the bottom left of the back of the base. If the device still does

not work, call Aroma Customer Service at 1-800-276-6286.

My blender stopped suddenly mid-use and I cannot get it to start again.

It is possible that your blender has overloaded or overheated. Your Aroma Professional

Blender is equipped with an automatic overload fail-safe that automatically shuts off the

machine for safety when overloaded with electricity or heat (see page 4). To reset the unit after

an automatic shut off, simply press the circuit breaker reset button located on the bottom left of

the back of the base.

In case of overheating, simply wait 15 minutes for the motor to cool, and the unit should

resume functionality.

The blade does not rotate smoothly and the machine makes loud abnormal sounds.

The retainer nut in the Container may have come loose. Stop using immediately and contact

Aroma Customer Service at 1-800-276-6286.