Aerfast SUB20 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водонагреватель Aerfast SUB20. Aerfast SUB20 15 страниц. External mobile tank
Печатать страницуOperating Procedures
Filling the Portable Air Tank
Take your portable air tank to any source of clean dry
compressed air. It is recommended that you fill your tank
with air until the pressure gauge reads between 6.5 to 9
bar. The air tank is filled like a car tire by pressing the chuck
from the source to the filler valve.
PLEASE NOTE: Tank can be filled and the pressure
gauge can be read with the RED ON/OFF KNOB in
the OFF position.
Using the Portable Air Tank
Turn the RED ON/OFF KNOB counter-clockwise to the
open position to allow air to flow from the tank into the hose.
To prevent air from leaking out of the tank between uses,
turn the RED ON/OFF KNOB clockwise to the closed
position.
Storage
STORING YOUR PORTABLE AIR TANK
Turn the RED ON/OFF KNOB CLOCKWISE to the OFF
position when storing your air tank.
WARNING
Failure to remove condensation will cause the tank to rust
prematurely.
Always drain the tank of all air after the last use for the day
and before repairing or removing any component parts.
Point the safety pressure relief valve AWAY FROM YOUR
BODY when releasing air. Use the pull ring on the safety
relief valve to vent any pressure inside the tank before
attempting to service the tank. Safety goggles must be worn
at all times for eye protection.To disperse any accumulated
condensation inside the tank, begin by reducing the air
pressure inside the tank by pulling out on the safety valve
and holding until the tank gauge reaches 1.5 bar. Invert the
tank with the manifold facing downward and pull the ring on
the safety relief valve. We as the manufacturer and you as
the consumer have no control over the moisture content of
air coming from any fill source. Premature rusting caused by
condensation inside the tank is the primary reason for the
suggested replacement date stamped on the tank.
Never attempt to remove any components while tank is
ressurized.
Never remove or deface the information sticker on tank.
Never attempt to fill the tank if any air leak is detected in
the tank body. Discontinue use of the air tank immediately.
Warranty is void if any attempt is made to alter or modify.
Parts List
Carry Handle
1
Pressure Gauge
2
Indicates internal air pressure of tank.
Pressure regulator.
3
Safety valve
4
Ball valve for filling air
5
Quick connector
6
Connect air hose from compressor here to fii the sub-tank
Quick connecor
7
Connect the air hose which is connected with your tools
here.
Ball valve
8
When finished working with the sub-tank always remember
to empty the tank from air and drain any condence water.
2
3
4
8
7
2
1
5
6
EN