Disney CR-410 Инструкция по применению - Страница 2
Просмотреть онлайн или скачать pdf Инструкция по применению для Динамики Disney CR-410. Disney CR-410 2 страницы. High-octane beats mp3 speaker
Печатать страницуGetting Started
Installing the Batteries
Note: Batteries should always be installed by an adult.
³ Use a Phillips screwdriver to open the battery
compartment door located on the bottom of the unit.
Install 3 AA size batteries, making sure that the +
and – polarities match the diagram printed inside
the battery compartment.
Close the battery compartment door and tighten
the battery door screw. Do not over-tighten.
For the Best Possible Performance
• We recommend the use of alkaline batteries for longer life.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
• Batteries are to be inserted with correct polarity.
• Remove exhausted batteries from the unit.
• Do not attempt to recharge non-rechargeable
batteries.
• Remove the rechargeable batteries from the unit
before charging.
• The supply terminals are not to be short-circuited.
• Batteries should be removed if the item will not be
used for an extended period of time, such as a month
or longer, to prevent battery leakage or damage.
• Rechargeable batteries should only be charged under
adult supervision.
• Only batteries of the same or equivalent type as
recommended are to be used
Note
Please note that the DEMO position on the MP3 / Off /
Demo Switch located on the bottom of the unit is for
store use only. When you use this unit at home, please
keep this switch in the MP3 position or the OFF position.
Built-in Speech
Press the unit's Play Button multiple times when the
MP3 / Off / Demo Switch is in the MP3 position to cycle
through the built-in speech. Be sure to turn the unit
off when you are done. (See #4 in the "Using the MP3
Speaker" section for more details on how to turn the unit
off.)
³
Battery Installation
·
Play Button
LED Headlights
Using the MP3 Speaker
Listening to an iPod/MP3 player or other audio device
1. Move the MP3 /OFF/ DEMO Switch to MP3.
2. Plug the audio cable located on the bottom of the unit
into the headphone or Line-out Jack on your MP3
player or other audio device.
2. Turn on your MP3 player or other audio device and
press its play button.
3. Press the Play Button on unit. Sound effect will play
and then MP3 Line-in will be active. Headlights blink
while sound effect plays and will also blink every 5
minutes when unit is on. If needed, adjust the volume
on your audio device.
4. MP3 Speaker System will automatically turn off 30
minutes after the Play Button on the unit is pressed.
You can also turn it off immediately by holding the
Play Button on the unit for 3 seconds or by moving
the MP3 / OFF/ DEMO Switch to OFF.
NOTE: Connected iPhones can create audio interference
noise when a call is received. Turn on Airplane mode
to disable phone while playing music.
It is important to keep the MP3 Speaker System as dry
and clean as possible. Clean the MP3 Speaker System
with a soft cloth moistened only with mild soap and
water. Stronger cleaning agents are not recommended,
MP3 / OFF / DEMO Switch
as they may damage the cases.
Keep the MP3 Speaker System away from direct sunlight
or sources of excessive heat.
Do not allow dirt, sand, small particles, water, or other
Audio Cable
liquids to enter the casing of any of the toys.
Protect your furniture when placing the unit on natural
wood or wood with a lacquered or coated finish. A cloth
or other protection material should be placed between
the unit and the furniture.
If the unit will be left unused for an extended time period,
such as a month or longer, have an adult remove the
batteries to extend their life and to prevent possible
leaking or corrosion.
Maintenance