Displays2go 2TCASE Инструкции - Страница 2

Просмотреть онлайн или скачать pdf Инструкции для Витрина Displays2go 2TCASE. Displays2go 2TCASE 2 страницы.

Step 9: Connect all wires on top of the case.

After completing the wire assembly,

place the top cover over the wires. Make

sure all wires are pushed down & in so

that the top over is properly seated on

the unit.

Step 10: Using (2) people, carefully pick up the

top case assembly. The (4) male

connector rods on the bottom of the

top case assembly should fully sit inside

the extrusion on the bottom case

assembly.

Very Important: The top case assembly must be picked up by

the front & back panels. The side panels of the top case

assembly are not secured & will slide out of the unit if not

picked up properly.Highly recommended to see our

assembly video online under the SKU: 2TCASESLVS &

2TCASESBLKL

2TCASE - Display Case

*** 2 People are needed for assembly***

Step 11: With all doors open on both the

top & bottom cases, proceed to

connect the wiring from the

bottom case to the wiring on

the top case.

Step 12: Connect all side bulbs

Step 13: Insert rubber pieces into the

metal shelf holders

Step 14: Place all shelves in (frosted shelf

goes in base of top unit)

Frosted Shelf

Step 15: Plug in

Page 2