3dEPP EPP Yak 55 Руководство по сборке - Страница 11

Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушка 3dEPP EPP Yak 55. 3dEPP EPP Yak 55 19 страниц.

21. Install the pre-bent z bend music wire into the aileron servo control arm. Make sure the

aileron servo is centered for the next step. It is very important to make sure the servo is

centered. Next slide a piece of heat shrink tubing onto the carbon rod. Now hold the

carbon rod and the music wire on the forward side up by the servo parallel to each

other and super glue together making sure again the aileron servo stays centered and

the aileron is flat on table (it may be necessary to trim the carbon rod if it is to long and

extending past the control horn). Once the two are glued together make sure the

aileron is streamline with the inboard side of the wing when servo is centered. Slide the

heat shrink tubing over the carbon and music wire. Being very careful and making sure

you do not to get to close to the foam use a lighter to shrink the tubing over the carbon

rod and music wire. If using kicker the foam will absorb the kicker which will ignite

and burn the foam. Repeat the process for the opposite aileron.