Alto DYNAMIC X-TRA Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мойка высокого давления Alto DYNAMIC X-TRA. Alto DYNAMIC X-TRA 11 страниц. High pressure washer

Alto DYNAMIC X-TRA Руководство по эксплуатации

1.0 Preparation

Before starting up your high pressure washer, we
advise you to carefully read through this instruction
manual. Follow all instructions to minimize the risk
of injuries when using the machine.

Prior to operation

Before starting up your machine please check it
carefully for any defects. If you find any, do not start
up your machine and contact your ALTO distributor.
Especially check:
l The insulation of the electric cable should be
faultless and without any cracks. If the electric
cable is damaged, it should be replaced by an
authorized ALTO distributor.

Mains power connection

The following should be observed when connecting
the high pressure washer to the electric installation:
l Only connect the machine to an installation with
earth connection.
l The electric installation shall be made by a certi-
fied electrician.
l It is strongly recommended that the electric sup-
ply to this machine should include a residual
current device (GFCI).
Extension cable
Extension cables should be of a watertight con-
struction and comply with the below-mentioned
requirements for length and cable dimensions.
1,0 mm²
1,5 mm²
2,5 mm²
l Cable connections should be kept dry and off the
ground.
l Always uncoil the extension cable completely to
avoid heat damage to the cable.

Water connection

Connect the high pressure washer by means of a
water hose to the water tap (inlet water, max. pres-
sure: 10 bar, max. temperature: 60°C. You may use
an ordinary 1⁄2" garden hose of min. 5 m and max.
25 m. Attach the hose using a quick connector.
NOTE: Connection to the public mains according to
regulations.
4
max 12,5
m
max
20
m
max
30
m
IMPORTANT! Only use water without any impu-
rities. If there is a risk of running sand in the inlet
water (i.e. from your own well), a filter should be
mounted.

Safety precautions

l WARNING! High pressure jets can be
dangerous. Never direct the water jet
at persons, pets, live electrical equip-
ment or the machine itself.
l The operator and anyone in the im-
mediate vicinity of the site of cleaning
should take action to protect them-
selves from being struck by debris
dislodged during operation. Wear goggles during
operation.
l Never try to clean clothes or footwear on yourself
or other persons.
l Do not let children or people who have not read
the instruction manual operate the machine.
l Never use the machine in an environment where
there could be a danger of explosion. If any doubt
arises, please contact the local authorities.
l It is not allowed to clean asbestos-containing
surfaces with high pressure.

Safety devices

Locking device on spray handle
The spray handle features a locking device (4b).
When the pawl is activated, the spray handle cannot
be operated.
Motor protection
The washer features an overcurrent release for pro-
tection of the motor against overloading. In the case
of an increased power consumption (maloperation)
the power supply for the motor will automatically be
disconnected.
If the motor overload system engages the washer
should be restarted. Turn the power switch to posi-
tion O and then to position I.
(Please refer to section "Troubleshooting and
correction").