3DR Quad DIY Kit Руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Квадрокоптеры 3DR Quad DIY Kit. 3DR Quad DIY Kit 8 страниц.

Attach APM plate to top plate

Now we'll attach the APM plate to the top plate. The APM plate

connects to the ends of the four 30 mm bolts securing the inside

holes of the arms. Place the four holes in the APM plate over the

exposed 30 mm bolts on the top plate and secure with 30 mm

threaded spacers.

Attach accessory plate to APM plate

Place accessory plate on top of APM plate, and align

the four 30 mm spacers with the four holes in the

accessory plate. Secure accessory plate to spacers

using four 5 mm nylon bolts.

30 mm spacer + 5 mm nylon bolt

Connect APM to power module and PDB

Locate the PDB four-wire cable (multicolored) and the power module six-position cable (red

and black); thread these cables up through the slots in the APM plate where they can connect

to the APM.

PDB wire

positions

PDB to APM wiring

Connect RC receiver to APM

When you're ready to install an RC receiver module, use the provided four-wire and two-wire

cables to connect to APM. Using the four-wire cable, connect the receiver's channel pins

to the corresponding APM Input signal pins. Use the two-wire cable to connect power and

ground pins between APM and the receiver to provide power to the receiver.

Accessory plate

APM plate

Connect the power module six-position cable

(red and black) to the APM PM port. Connect the

APM output

pin positions

PDB four-wire cable (multicolored) to the APM

Outputs signal pins (top row). Ensure that the

wire originating in the position on the PDB pins

labeled M1 connects to the APM Output signal

pin labeled 1, the M4 wire connects to position

4, etc.

APM plate

30 mm bolt + 30 mm spacer

Complete plate assembly