Balt JPM-1 Инструкции по сборке - Страница 4

Просмотреть онлайн или скачать pdf Инструкции по сборке для Стойки и подставки Balt JPM-1. Balt JPM-1 5 страниц. Adjustable printer stand

Печатать страницу

1. FOR LARGE PRINTERS

Attach 2 Long Metal Plates (P-3)

[through outer holes] and 4 Short

Metal plates (P-4) to the Leg Frames

using 4 Screws (A1), 4 Flat Washers

(K) and 4 Wing Nuts (J).

Note: Long Metal Plates should be

attached with Channel side down,

and Short Metal Plates with the

channel side up.

P-4

3. FOR NARROW PRINTERS

Attach 2 Long Metal Plates (P-3)

[through outer holes] to the Leg Frames

using 4 Screws (A), 4 Flat Washers (K)

and 4 Wing Nuts (J).

Then attach 4 Short Metal Plates (P-4)

through the inner holes on the Long Metal

Plate using 4 Screws (A1), 4 Flat Washers

(K) and 4 Wing Nuts (J).

The Balt product you have purchased is guaranteed against material and workmanship defects.

This guarantee extends 1 year from date of purchase. Should this product fail to function satisfactorily under normal

use due to defect or imperfection, the defective part or product will be replaced.

Damage caused by common carriers during shipment is not included in this guarantee.

This guarantee sets forth all applicable guarantees and remedies. No other warranty, expressed or implied shall apply.

Failure to follow instructions found in Important Information Section of Owner Sheet shall void the guarantee.

Monday - Friday 8 a.m. - 5 p.m.

Toll-Free Customer Service 1-800-749-2258

OPTION # 2

P-3

Inner Hole

OPTION # 3

Important

Consequential or incidental damages and or costs are not refundable.

Should you require assistance during assembly,

please call our Customer Service Department

OPTION # 1

P-4

2. FOR EXTRA STABILITY

WITH LARGE PRINTERS

Attach the Long Metal Plates (P-3)

Outer Hole

and Short Metal Plates (P-4) same

as for the large Printers. Then attach

Short Metal Plates through the inner

holes on the Long Metal Plate using

4 Screws (A1), 4 Flat Washers (K)

and 4 Wing Nuts (J) for added

stability.

P-4

Central Standard Time

Outer Hole

P-3