3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для 3D-принтеры 3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit. 3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit 20 страниц.

Печатать страницу
Assemble Panels
1. Attach The Front Door Frame Corners

Each of the corners on the enclosure will be held together by the connectors pictured
below. There are only two versions L and R, which can be identified by the letters
stamped on the inside. The opposite connectors are identical, i.e. Bottom Right is the
same as Top Left. In all cases the surface of the connector with the cutout pattern
faces front or back.
The front door is designed so that the latches are on the left. Attach the corner
connectors on the back side of the door frame using the provided cap head 12mm
screws. See the photos below. The top of the connector should be flush with the top
of the acrylic.


Top Left
Bottom Left
Copyright 2020 3DUpfitters
Top Right
Bottom Right
6