3DUpFitters Ender 5 Plus R1 Enclosure Kit Руководство по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке для 3D-принтеры 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 страниц.

Печатать страницу

Attach the doorknob by ﬁrst inserting the square M4 nut

into the slot. Use a 16mm cap head screw to attach the

door.

Now that the latches are mounted, it is time to connect

the strike plates. Each plate comes with a squishy

adhesive covering the exact size of the plate. Carefully

attach the adhesive side to the acrylic at the location of

each latch. Then, adjust the width of the metal strike plate so that it is held on by the

pressure of the two sides of the plate. The adhesive covering will keep the metal strike

plate from scratching the acrylic.

2. Left Side Panel

Attach the left side to the front forming an L-shape

that will stand up on its own, then attach one L and

one R connector at the back. Then attach the two

mid-panel connectors on the top and back as shown.

The Ender 5 Plus design adds a side port for a

grommet and grommet holder. This makes it easy to

take oﬀ the enclosure without unplugging the printer.

First, insert the grommet into the grommet holder,

then run the power supply cable through it, for easy

access to the extruder. The assembly slips into the

similarly shaped opening in the left-side acrylic.