CamJam EduKit 3 Инструкция по сборке Руководство

Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Учебное оборудование CamJam EduKit 3. CamJam EduKit 3 6 страниц.

CamJam EduKit #3 - Assembly Instructions

Due to the use of power tools and knives, adult assistance is required



CamJam EduKit #3



Raspberry Pi



Raspberry Pi Power Supply



4 AA batteries



Velcro



Drill with 1/4" and 7/16" drill bits



Scissors



Sharp knife/ box cutter



Measuring tape/ Ruler



Small Phillips screwdriver

1. Drill 7/16" hole that is 2 1/8" from the front of the box, centered with the side walls. Trim loose

paper and board using a sharp knife to ensure hole is clear. This is for the optical line sensor.

2. Drill two ¼" holes in the box bottom for the motor wires as shown below. Cut 1 piece of 3M

tape into 2 equal pieces and apply to the two motors. Adhere the motors to the box bottom

and route the wires through the holes. Press the wheels onto the motor shafts. Ensure the

wheels are not rubbing on the box.

3. Apply 3M adhesive tape to plastic housing for the steel ball. Trim excessive tape.