ESI CLIMB2-SLV Руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Стойки и подставки ESI CLIMB2-SLV. ESI CLIMB2-SLV 10 страниц. Dual monitor sit/stand workstation

Печатать страницу

CLIMB2

Adjust Angle of Monitors, If Necessary

• Remove the plastic caps from the sides of the

VESA mount to allow access to the bolt and nut.

• Use the ½" socket wrench to loosen the bolt and

nut (counterclockwise). Tilt the VESA mount and

monitor to the desired viewing angle.

• After the adjustment is complete, tighten the

bolt and nut with the socket wrench (clockwise).

Replace the caps.

Adjust Position of Monitors, If Necessary

• The slots in the dual VESA mount allow for approximately

7½" of side-to-side adjustment for each monitor.

• Loosen the knob on the rear of each VESA mount to

enable side-to-side movement.

• Tighten the knob securely to hold the VESA mount and

monitor in the desired position.

Test Operation

• Depress the paddle lever. Raise and lower the unit through its full range of movement.

• Position the unit so the column is at a 90° angle. If necessary to fine tune operation of the product, make

one or both of the adjustments shown on page 8.

CAUTION: Keep both hands on the keyboard platform to control the rate of movement when depressing

the paddle lever.

ADJUSTMENT

Cap

½" Socket

Wrench

Loosen Knob

to Adjust