ESI ALL-FLEX FLEX3-WHT-V1 Руководство по сборке и эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Внутренняя отделка ESI ALL-FLEX FLEX3-WHT-V1. ESI ALL-FLEX FLEX3-WHT-V1 12 страниц. 3 leg electric table base
Печатать страницу
ALL-FLEX
3 LEG ELECTRIC TABLE BASE
™
STEP 12
Attach the control unit to the work surface.
• Slide the control unit under the bracket and
attach it using M5x18 wood screws. The motor
cable and keypad ports should face away from
the center column.
• Allow at least 2¼" (57mm) between the back of
the control unit and the center column assembly
to allow room for power cord attachment.
STEP 13
Attach the digital keypad flush with the front edge of
the work surface.
• Use the two M4x23 wood screws.
• Attach the keypad on the same side as
the control unit.
STEP 14
Make connections to the control unit.
• Connect the cable from the digital keypad.
• Connect the motor cables from the three motors.
• Connect the power cord to the control unit.
• Plug the power cord into an AC outlet.
CAUTION: Do not operate the table until after
"zero setting" the system. See the following step.
8
M5x18
Control Unit
Digital Keypad
flush with the work
surface edge
Digital
Keypad
Cable
Motor
Cables
ASSEMBLY
M4x23
Power
Cable
Control
Unit