ESI activ 08 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики ESI activ 08. ESI activ 08 10 страниц. Top quality 8” active studio reference monitor
Печатать страницу
ESI
aktiv 08
1. Introduction
Congratulations on your purchase of the ESI aktiv 08.
The aktiv 08 top quality near field reference monitor has been developed to generate a professional
level sonic reproduction in any studio environment. With an extended low frequency response and a
top quality kevlar 8" driver, the stylish aktiv 08 delivers unparalleled punch in the low-mid
frequency – a major improvement over the paper and polypropylene drivers used in many
comparable products. The monitor also provides frequency response adjustment controls, allowing
you to tune the sound, specific to the needs inside your studio environment. They feature a German
optimized version of ESI's cross over technology that is perfect to provide an optimal output signal
and frequency response properly matching the used drivers and the cabinet design. aktiv 08 is
magnetically shielded for desktop operation next to your other electronic equipment without
causing interference.
2. Basics & Installation
For optimal performance of aktiv 08, read the instructions in this manual thoroughly and carefully
before you are using the speaker. We tried to keep this manual short so that you are not loosing
much time to read through it completely.
Unpacking / Handling
To remove the monitor from the carton its best to turn the package carefully upside down on the
floor or on a table and then lift the carton vertically up slowly to leave the monitor resting in the
packaging foam. Make sure that you don't grab the speaker driver units on the front to avoid
damage. Now check the monitor for signs of damage that might have occurred in shipping. In the
unlikely event of this, please contact the reseller of the product immediately. Be careful when you
remove the packaging foam. Please keep all packing materials.
Connection
High quality XLR balanced or TS unbalanced audio cables are recommended for input connection.
The monitor typically connects to the line level output of a mixing console or to a computer audio
card. Make sure the power of the monitor is switched off before you connect any audio cables. Also
turn down the volume initially.
XLR balanced connection
Connect male side of XLR balanced cable to the balanced XLR input of aktiv 08. Make sure the
power cable is connected as well. Setup all speakers (i.e. left / right channels) with the same type of
cable.
TS unbalanced connection
Connect male side of TS unbalanced cable to the input jack of aktiv 08. Make sure the power cable
is connected as well. Setup all speakers (i.e. left / right channels) with the same type of cable.
4