Clearmount SW7 Инструкции по сборке - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по сборке для Пила Clearmount SW7. Clearmount SW7 6 страниц. Miter saw scale

A A T T T T A A C C H H I I N N G G Y Y O O U U R R S S C C A A L L E E T T O O T T H H E E S S A A W W : :

• Place scale on your miter saw

• If your saw has an adjustable fence, make sure it is positioned as far back as possible from the front of saw

• Line up pencil mark (on back fence of scale base) with your saw blade at 0 degrees - saw should be

unplugged at this point.

** If you purchased a complete system from us, we have already drilled your saw(s) - skip to

instructions on Bolting.

(Double Miter Scale - Start with the saw that is on the Right side as you are facing the unit. After

you have secured this one, repeat the same procedure for attaching the second saw.)

• Feel underneath the table of your saw, under the pilot hole that is marked for you to use, to see

that they will be clear of reinforcement walls when you drill.

• The scale base must be held or clamped firmly against the miter saw's fence when you drill.

• Using an electric drill with a ¼" drill bit, guide the bit through the pilot hole you have selected and

drill a hole through the base of your saw. You only need one hole/bolt per side.

Bolting: Insert a bolt through the scale base and your saw and secure and tighten with the nut under

neath your saw.

• Repeat this on the other side of your saw.

page 3

NSERT

OLT

NSERT

OLT