Alto-Shaam HALO HEAT 750-GDU Установка, эксплуатация и обслуживание - Страница 7
Просмотреть онлайн или скачать pdf Установка, эксплуатация и обслуживание для Мерчендайзер Alto-Shaam HALO HEAT 750-GDU. Alto-Shaam HALO HEAT 750-GDU 19 страниц. Lighted display cabinets, hot food
Также для Alto-Shaam HALO HEAT 750-GDU: Брошюра и технические характеристики (4 страниц), Технический паспорт (2 страниц), Руководство по эксплуатации и уходу (16 страниц)
Печатать страницу
U s e r S a fe t y I n fo r m a t i o n
This appliance is intended for use in commercial
establishments where all operators are familiar with
the purpose, limitations, and associated hazards of
this appliance. Operating instructions and warn-
ings must be read and understood by all operators
and users.
1. Make sure the unit is connected to the
appropriate power source.
2. Use hand protection when handling
hot items.
3. Preheat the unit for 30 minutes before use.
4. Be certain only hot foods are placed
into the cabinet.
5. To avoid personal injury and damage
to the unit, treat glass with care.
Remember –– glass can shatter.
P R O D U C T \ P A N C A P A C I T Y
— Two (2) side racks spaced at 3" (76mm) centers
— Three (3) chrome plated wire shelves
— Two (2) 40 watt appliance lamps
O P E R AT I O N
36 lbs (16 kg)
FULL-SIZE SHEET PANS: Six (6) 18" x 26" x 1"
HALF-SIZE SHEET PANS: Six (6) 18" x 13" x 1"
—
up to twelve (12) with additional wire shelves
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION.
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
# 8 2 8 O p e r a t i o n a n d C a r e M a n u a l • 6.
HEATING CHARACTERISTICS
The cabinet is equipped with a special, low heat
density, heating cable. Through the Halo Heat con-
cept, the heating cable is mounted against the walls
of the warming compartment to provide an evenly
applied, thermostat controlled, heat source. The
design and operational characteristics of the cabinet
eliminate the need for a moisture pan or a heat
circulating fan. Through even heat application,
the quality of a food product is maintained up to
several hours.
The performance of this unit has been
optimized using the factory provided bulbs.
These bulbs should be replaced with an
exact replacement or with a factory
recommended replacement. These bulbs
have been treated to resist breakage and
must be replaced with similarly treated
bulbs in order to maintain compliance with
NSF standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
MAXIMUM
(457mm x 660mm x 254mm)
(457mm x 330mm x 254mm)
TO AVOID BURNS,