Alto-Shaam HALO HEAT HOT 2GO Руководство по эксплуатации и уходу - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и уходу для Мерчендайзер Alto-Shaam HALO HEAT HOT 2GO. Alto-Shaam HALO HEAT HOT 2GO 13 страниц. Hot merchandiser
Печатать страницу
1 0 0 0 - H M • O P E R A T I O N A L P R O C E D U R E S
Thermostat Control Description and Function
INDICATOR L.E.D.
ERROR CODE
INDICATOR L.E.D.
The L.E.D., Light Emitting Diode, referred to is an electronic
device providing illumination.
The control has a three-digit L.E.D. display. When the warming
cabinet is in operation, the L.E.D. will show the chamber's internal
temperature. The display will also show programming and diag-
nostic information.
ON/OFF Rocker Switch
The Power On/Off Rocker Switch positions
may be marked with the international "I" for
On and "O" for Off.
POWER
ON/OFF
ROCKER SWITCH
UP/DOWN Arrow Rocker Button
The UP/DOWN arrow rocker button is used to
increase or decrease the set-point temperature. The
minimum set-point temperature is 90°F (32°C) while
the maximum set-point temperature is 200°F (93°C).
SET Button
SET
The SET button is used to display the current
set-point temperature or program a new set-point
temperature. Pushing the SET button once will dis-
play the set-point temperature value for five seconds.
Holding the SET button allows the programming
mode to become active.
L.E.D.1
L.E.D. Display
The L.E.D. display will show the set-point
temperature value when programming, or the
200
warming chamber's temperature when calling
for heat. When programming a new set-point
temperature, the L.E.D.1 indicator with blink.
°F
When a new set-point temperature is chosen,
CHAMBER
the Chamber Temperature L.E.D. will flash
TEMPERATURE
L.E.D.
three times to confirm.
HEAT
L.E.D.1
200
!
CHAMBER
TEMPERATURE
L.E.D.
INCREASE / DECREASE
BUTTON
prg
SET
TEMPERATURE
SET
BUTTON
HEAT
INDICATOR L.E.D.
ooo
!
ERROR CODE
INDICATOR L.E.D.
HEAT
INDICATOR L.E.D.
CCC
!
ERROR CODE
INDICATOR L.E.D.
!
Operation & Care Manual #835 • 2.
POWER
ON/OFF
ROCKER SWITCH
HEAT INDICATOR L.E.D.
The Heat Indicator L.E.D. will illuminate and
remain lit while the unit is calling for heat.
It will go out when the air temperature inside
the warming chamber reaches the set-point
temperature on the control.
ERROR CODE DISPLAYS
Open-Circuited
L.E.D.1
If "ooo" is displayed in the Error Code L.E.D.,
the sensor is open-circuited. Follow Trouble
Shooting Guide instructions in this Operation
°F
and Care Manual.
ERROR
CODE
DISPLAY
Short-Circuited
L.E.D.1
If "ccc" is displayed in the Error Code L.E.D.,
the sensor is short-circuited. Follow Trouble
Shooting Guide instructions in this Operation
°F
and Care Manual.
ERROR
CODE
DISPLAY
ERROR CODE INDICATOR L.E.D.
If either of the above mentioned errors codes
should occur, the Error Code Indicator L.E.D. will
be illuminated and remain so until error is cleared.