ClearOne UNITE 160 Краткое руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для IP-камера ClearOne UNITE 160. ClearOne UNITE 160 8 страниц. 4k camera
Также для ClearOne UNITE 160: Руководство пользователя (19 страниц), Краткое руководство по эксплуатации (6 страниц), Краткое руководство по эксплуатации (8 страниц)
Печатать страницуCOLLABORATE® Versa™ Room CT 160
Versa USB
You can mount the Versa USB in the following ways:
•
Standard equipment rack
•
Bottom side of a table top
Note: Mounting hardware such as screws and anchors are not included with the Versa USB.
Required Tools
•
No. 1 Phillips screwdriver
•
T15 Torx screwdriver
•
Level (to level the Versa USB)
Standard Equipment Rack Mount
ClearOne offers a standard 1U rack shelf with 20 lb (9kg) weight capacity.
1. Determine location for rack shelf.
2. Align mounting holes on rack shelf mounting ears with holes on the rack (at determined location).
3. Insert the four #10-32 screws included with the ClearOne 1U rack shelf (or proper screws for your third-party
mount) and tighten.
Note: Remove pre-installed mounting ears on expander to fit up to 3 Versa USB units side-by-side on a single
ClearOne 1U rack shelf.
4. Torx drive screws secure the pre-installed mounting ears to the main body of
the Versa USB. Remove them with a Torx T15 screwdriver. (optional)
5. Secure the Versa USB to the rack shelf. You must supply your own hardware
(four #6 or M3.5 screws) for securing the Versa USB.
Bottom Side of a Table Top Mount
Select your hardware based on your specific installation needs.
1. Determine the location for the Versa Hub.
2. Use a pencil to mark on the table the location of four mounting holes
that align with the mounting holes on the Versa USB mounting ears.
3. Determine the proper depth and diameter for the holes.
4. Drill four pilot holes for #6 or M3.5 screws.
5. Align the mounting holes on the Versa USB mounting ears with the
pilot holes.
6. Use four #6 or M3.5 screws to attach the Versa Hub to the table.
Wall Mount
Select your hardware based on your specific installation needs.
1. Determine location for the Versa USB.
2. Use a pencil to mark on the table the location of four mounting holes that align with the mounting holes on the
Versa USB mounting ears. If needed, use a level.
3. With the proper size drill bits, drill four pilot holes for fasteners/anchors.
4. Install the fasteners/anchors in the wall.
5. Align the mounting holes on the Versa USB mounting ears with the pilot holes.
6. Use four #6 or M3.5 screws to attach the Versa Hub to the wall.
Note: Anchors and screws to mount the Versa USB are not provided. The installer must select them for the wall
material that supports the unit. Exercise care when you drill and install anchors so wall material does not tear out
and weaken the attachment.
5
•
On a wall
•
Above the ceiling
•
Drill bits appropriate for anchors
•
Electric drill
•
Drywall saw (for cutting hole in wall or ceiling)
Quick-Start Guide
QSG-0169-001v1.0 May 2023