1 BY ONE H005 Руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Проигрыватель 1 BY ONE H005. 1 BY ONE H005 14 страниц. Belt drive turntable system

This turntable is supplied with a factory-fitted cartridge that's already adjusted.

Note: Instructions provided in this manual for adjusting the cartridge are provided in

case the cartridge is replaced at a later date by a different model.

Installing the turntable

• Mount the turntable on a level surface.

• To avoid the effects of vibrations and acoustic pressure, do not mount the turntable

next to items such as speakers.

• The turntable may pick up radio static if placed next to a radio. Therefore, try to keep

the turntable away from transmission devices such as radios.

• If the turntable is near equipment (cell phone, etc.) that emits strong radio waves,

noise may occur.

Turntable Platter and Belt Setup

1. Turn the platter over and check the belt position.

Make sure that the drive belt is looped in the middle of the circle. The drive belt

located too high or too low in this circle may cause the drive belt to fall off or speed

to be unstable.

2. Set the platter on the spindle.

• Make sure that the platter is fully seated on the spindle.

Opening

Motor pulley

Spindle

3. Place the belt on the motor pulley.

• Align one of the platter openings with the motor pulley, and, while pulling both

ends of the red ribbon that comes attached to the belt, place the belt on the

motor pulley, as per the diagram. When doing this, be careful not to twist the belt.

Ribbon

Belt

Straight

4. Remove the red ribbon from the belt.

Platter

Motor Pulley

Twisted

Wrong location