Alton ECOMAX ELG03 Руководство по эксплуатации - Страница 13
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Триммер Alton ECOMAX ELG03. Alton ECOMAX ELG03 14 страниц. 18v cordless string trimmer
Печатать страницу
Separate collection of used machine and packaging let you recycle
materials and use them again. Use of the recycled materials helps
prevent environmental pollution and decreases the requirements for
raw materials.
At the end of their useful life discard batteries with a precaution for our
environment. The battery contains materials that is dangerous to you
and the environment. You must remove and discard these materials
separately at a equipment that accepts lithium-ion batteries.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
No electrical contact
between the machine
and the battery pack.
The machine does
not start when you
The battery pack is
push the trigger.
depleted.
The lock-out button and
trigger are not pushed
at the same time.
The guard is not
attached to the machine.
Heavy cutting line is
The machine
used.
smokes during
operation.
The grass winds around
the motor shaft or the
trimmer head.
21
SOLUTION
1. Remove battery pack.
2. Check contact and install
the battery pack again.
The battery pack is
depleted.
The lock-out button and
trigger are not pushed
at the same time.
Remove the battery pack
and attach the guard to the
machine
Use only with the nylon
cutting line of 2.0 mm
diameter.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from
the motor shaft and
trimmer head.
The motor is overloaded.
The machine
smokes during
operation.
The battery pack or
machine is too hot.
The battery pack is
disconnected from the
tool.
The battery pack is
depleted.
Lines are welded to
themselves.
Not enough line on
spool.
The line does not
advance.
Lines are worn too short.
Lines are tangled on
spool
1. Remove the trimmer
head from the grass
2. The motor will recover
to work as soon as the load
is removed
3. When you cut, move the
trimmer head in and out
of the grass to be cut and
remove no more than 8"in
pass.
1. Cool the battery pack
until its function returns
to normal
2. Cool the machine for
approximately 10 minutes
Install the battery pack
again.
Charge the battery pack.
Lubricate with silicone
spray.
Install more line.
Advance the cutting line.
1. Remove the lines from
the spool.
2. Wind the lines.
22