3form LightBox Краткое руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Осветительное оборудование 3form LightBox. 3form LightBox 15 страниц.

Backlighting

LightBox

Installation

Remove Face Panel

unpackage LightBox and remove the face panel. The face panel is affixed to the LightBox with 3M Dual Lock tape. The LightBox is

shipped with shims behind the face panel to prevent the Dual Lock from engaging. Once the Dual Lock is engaged, it will require

prying the face out with a thin flat screwdriver. Being careful not to scratch the frame or face, pry the face out starting in one

corner and then pull the face out.

Hardwire

Determine where the LightBox will be mounted and remote location for the power supply. Hardwire the power supply to line

voltage and connect to the provided 16' cable. If the power supply must be mounted more than 16' from the LightBox, the wires

can be extended up to 50' using minimum 18 AWG wire. (See the Wiring Diagram on page 5 and Dimming Wiring Diagrams

on page 5 - page 6)

Fasten To Wall

Fasten LightBox to the wall. A

standard 48" � 48" LightBox

weighs about 75 lbs., so blocking

or attachment to studs is

recommended. The LightBox

comes from the factory with (8)

1/4" pre-drilled mounting holes

through the frame at 9" from

each corner.

Additional mounting holes can

be drilled through the frame

along the drill guide lines. use

appropriate wood screws or

anchors depending on the

mounting substrate. #10 or 3/16"

diameter fasteners are

recommended.

For more information, please visit 3-form.com or call 800.726.0126

Overall View

Solution Document

Section View

16' Cable

3-6 -765 Power Supply

1¼"

Wall