ClearSpan CL108543 Руководство - Страница 14

Просмотреть онлайн или скачать pdf Руководство для Палатка ClearSpan CL108543. ClearSpan CL108543 17 страниц.

Печатать страницу

CLEARSPAN

FABRIC STRUCTURES

™

ATTACH MAIN COVER

Gather the parts:

•

Main cover (with conduits inserted)

•

Ropes (provided by customer) or strap long enough to reach over the frame

•

Box cutter or utility knife

WARNING: To prevent damage and injury, do not leave the cover

unattended if it has not been properly secured. The ropes can be used to

temporarily keep the cover from blowing off the frame.

Assembly Procedure

To pull the cover over the frame, attach ropes or straps to both ends of the

cover conduit positioned furthest from the frame (or on top of a fan-folded

cover). Wrap the rope around the conduit to prevent it from slipping off.

NOTE: It may be necessary to attach

additional ropes to the cover conduit

between the end ropes by cutting a small

opening in the cover pocket and tying the

rope around the conduit. DO NOT cut

through the main cover. Cut through the

conduit pocket only.

With all ropes attached to the cover conduit, lift and carry the conduit and

cover toward the base of the assembled frame. (Skip if cover is fan-folded.)

Set the conduit down, toss the ropes over the frame, and pull the cover into

position. Position one person at each rope. Verify that the cover pockets are

to the inside of the building. This will be the underside of the cover when it

is pulled into position on the frame.

NOTE: Use lifts

and additional

assistants (if

needed) to help

pull the cover

up and over the

frame.

Cover

Conduit

Shelter shown above may be a different style or length.

Once the main cover is pulled into position, center the cover on the frame

(end-to-end and side-to-side).

WARNING: To prevent damage and injury, do not leave the cover

unattended if it has not been properly secured.

Locate the black straps at the front and rear hems and feed the straps

through the center slot in each end ratchet (QH1061). Operate the ratchet

to wrap the strap onto the center hub just enough to keep the strap secure.

NOTE: Cover shown

may differ from the

actual cover for your

building.

Photo shows the

QH1061 ratchet

attached to the end

rafter. QH1061 is

used to secure the

bonnet portion of the

main cover.

NOTE: Do not tighten completely at this time. This helps to temporarily

secure the cover.

Tie the ropes (or straps), used to pull the cover into position, to the frame to

help hold the cover.

Continue with the installation of the side straps.

Ropes

Main Cover

Bonnet

Revision date: 09.08.09