ClearSpan R030A00008 Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Палатка ClearSpan R030A00008. ClearSpan R030A00008 13 страниц. Twin-wall polycarbonate end panel kit 30' wide & 35' wide

Печатать страницу

END PANEL INSTALLATION (continued)

Measure the distance between the H-channel installed along

the sides of the center panel (or panels) and cut H-channel to

the that length. See diagrams for panel size.

Install H-channel along the top of the installed lower panel (or

panels). Upper panels slide into this H-channel (diagram B).

Set the first upper panel in place into the H-channel of the

lower panel and align the edges with the lower panel. Do not

attach at this time. Have an assistant hold the panel against

the end frame. Do not install panels on windy or stormy days.

10.

Using the end rafter end cap as a guide, trace along the end

cap to mark the panel height. Set the panel on a protected

surface and cut the panel to the correct size. Cut the panel

approximately 1/4" shorter to allow for easier installation.

Tape the cells at the upper end using vent tape.

11.

Measure the distance along the vertical edges of the panel

sides and cut H-channel to the measured length. H-channel,

when installed properly, is positioned under the end cap with

the panel. Use the end cap as a guide to properly cut the

upper end of the H-channel.

12.

Set the panel back in place,

to the outside, against the end wall and install the H-channel

along the edges. Top end of the side H-channel fits under the

lip of the end cap and slides onto the polycarbonate panel.

13.

Verify that the panel is square and in the desired position,

and attach the panel to the end frame using Tek screws and

washers.

Actual end frame and panels may differ

from frame shown. Consult the panel

diagrams located in the Quick Start

section for the end kit ordered.

30' Wide End Wall

Measure each

distance for step 7.

Revision date: 06.02.09

End Panel Installation

with the UV-protected side facing

Trim

excess panel

4' x 8'

Panel

Ground Level

H-Channel

The horizontal dashed lines in the

diagram below show where to attach

the panels to the end frame. Install Tek

Trim

screws and washers through the panel

excess panel

and into the end wall girt. Evenly space

the screws at 12".

4' x 8'

Girt

Panel

Upper

Panel

Lower

Panel

End Cap

(End rafter is not shown.)

Panel