ClearSpan 104903 Инструкция по сборке Руководство - Страница 8
Просмотреть онлайн или скачать pdf Инструкция по сборке Руководство для Комплект для теплицы ClearSpan 104903. ClearSpan 104903 19 страниц. Premium solar star greenhouse
Печатать страницу13. Install a flat bracket a few inches in from each lower
corner of each angled panel on the inside to secure
the corner to the metal base frame.
14. Install the remaining smaller side panels as shown.
Reposition the pass-through brackets as needed.
NOTE: Brace the angled end panel in place (if needed).
Adjust the bottom, side frame rail if needed.
15. To prevent interfering with the door installation,
remove the screws from the angled panels along the
door edges. See vertical dashed lines above.
16. Set the door in the door opening and slide the end
panels together to sandwich the door in the opening.
ATTENTION: Lock the deadbolt of the door before you
slide the base rails together.
Visit www.ClearSpan.com for additional products and customer assistance.
17. Place one upper, triangle end panel in position on
18. Take the remaining triangular end panel, loosen the
Secure
panel to
ATTENTION: The lip of the metal trim at the bottom of
corner
the triangular panel will overlap the top of the doorframe.
bracket
Photo shows the upper triangular panel as installed.
the non-door end, align the edges and ends of the
panel with the lower panels, and secure the upper
panel using 3/4" Tek screws and 3" x 3" square
plates. (See the diagrams and photos that follow.)
screws along the bottom of the panel used to secure
the polycarbonate, and set the panel in position.
Loosen these screws before installing panel.
Figure 1
The open
tube ends
are covered
with flashing
later in these
instructions.
7 of 18