ClearSpan R035B00008 Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Комплект для теплицы ClearSpan R035B00008. ClearSpan R035B00008 13 страниц. Twin-wall polycarbonate end panel kit 30' wide & 35' wide
END PANEL INSTALLATION (continued)
14.
Repeat steps to install the next panel. Work from the center
outward to install the remaining panels.
35' wide: The center, upper panels include H-channel
installed on both sides and along the bottom edge. The
bottom H-channel is common between upper and lower
panels and connects the two panels.
15.
Finish the end wall using two (2) 6' x 10' panels on the
outer position of the end wall. Measure, cut, and install
panels as previously described. Cut the outer 6' x 10'
panels so each is flush with the side wall hat channel and
installed side panels (if equipped) of the main building.
NOTE: The edges of the two outer end panels must not
extend beyond the edge of the side wall hat channel and
installed sidewall panels. When installed, the panels of the
end wall and sidewall meet to form a finished edge at each
corner of the building.
16.
Measure and cut a section of 104213 profile and install it
along the outside edge of each outer panel to complete
installation (see drawing C).
17.
Install a Tek screw to secure the H-channel to the frame in
each place where H-channel crosses the end wall brace.
See letter D in the diagram below for an example.
18.
Continue by reading the care and maintenance section.
35' Wide End Wall
Panel pattern may vary. Refer to the panel
diagrams located in the Quick Start section
for the layout of panels for your end wall.
excess panel
Trim
excess panel
104213
6' x 12'
Panel
Outer Panel
8
End Panel Installation
Trim
excess panel
Trim
6' x 8'
6' x 8'
Panel
Panel
D
6' x 8'
6' x 8'
Panel
Panel
D
D
GROUND LEVEL
End
Panel
Trim
excess panel
Trim
excess panel
6' x 8'
6' x 8'
Panel
Panel
6' x 8'
6' x 8'
Panel
Panel
Outer End Wall
Panel
104213
Sidewall Hat
Channel
104213
C
Trim
excess panel
104213
D
C
6' x 12'
Panel
D
Outer Panel
D
Revision date: 06.04.10