Altrad BELLE COMPACT 350X Руководство по эксплуатации - Страница 13
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Altrad BELLE COMPACT 350X. Altrad BELLE COMPACT 350X 15 страниц.
Печатать страницу
Maintenance
The Altrad Belle 'Compact X' Floor Saw is designed to give many years of trouble free operation. It is, however, important that the
simple regular maintenance listed in this section is carried out. It is recommended that an approved Altrad Belle dealer carries out all
major maintenance and repairs. Always use genuine Altrad Belle replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine. Petrol engine - disconnect the HT lead from the
sparkplug. Always set the oor saw on level ground to ensure any uid levels will be correctly read. Only use recommended oils (see
chart on following page).
Running In Period
When the oor saw is rst used from new, the engine oil must be changed after the initial running in period (see engine manual for
full detail). The belt tension should be checked after 4 hours use. If new belts have been tted, Check belt tension after the rst 30
minutes of use.
Drive Belt
Remove the belt guard then check the belt tension by placing light nger pressure on the top of the belt, as near central between the
engine drive and arbor pulley. The belt should de ect by 4mm. If the belt tension requires adjustment, loosen the engine mounting
bolts enough to allow the engine to be moved. Adjust the engine's position by adjusting the tensioning bolt at the front of the machine.
Once set, retighten the engine mounting bolts and check the belt tension a second time. Once the belt tension is correct, check the
pulley alignment. If the alignment is incorrect, loosen the taperlock bushes and move the pulley to suit. Once the alignment is correct,
retighten the taperlock bushes. Finally, replace the belt guard ensuring it is correctly and securely tted.
Routine Maintenance
Engine Oil
Air Filter
Spark Plug
Drive Belt
Oil / Fuel Type & Quantity - Spark Plug Type
Petrol Honda GX390
Removal of Arbor Shaft
1. Remove belt guard, belts, lower taperlock bush and drive key.
2. Tilt machine backwards to allow access to arbor shaft bearings.
3. Heat grubscrews on bearings .
4. Remove the 2 grubscrews on the blade side and the 2 grubscrews on the drive bearing and remove the shaft.
5. Clean and replace arbor shaft and line the groove up on the blade end with the grubscrews.
6. Re-insert grubscrews at both ends and secure using loctite 638.
Service and Maintenance
Check Level
Change
Check Condition
Clean / Replace
Check / Clean
Tension
Quantity
Oil Type
S.A.E. 10W 30
After First
4 Hours
Fuel Type
(Litre)
1.1
Unleaded
13
First Month /
3 Months
20 Hours
/ 50 Hours
Capacity
Spark Plug
(Litre)
Type
BM6ES or
6.4
BPR6ES
GB
6 Months /
100 Hours
Electrode
Gap (mm)
0.6 - 0.7