ClearView Easy Slide Руководство по установке и эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Автомобильные аксессуары ClearView Easy Slide. ClearView Easy Slide 6 страниц.
Также для ClearView Easy Slide: Инструкция по сборке Руководство (16 страниц)
Печатать страницу
Positioning and mounting the Easy Slide
Place your fridge into the Easy Slide and return the slide into stowed position. Test the position of the Easy
Slide to ensure it remains clear of vehicle side trims and rear door in all possible configurations, including
closing the vehicle rear door with the Easy Slide in its secured stowed position. Take care when testing
whether the vehicle rear door can be closed without contacting the Easy Slide handle or fridge.
If the Easy Slide needs to be repositioned, simply remove temporary fixing screws and move the Easy Slide
into desired location. Ensure the Easy Slide does not extend further than the drawer front panels.
Once the position has been finalised, drill through drawer timber top using 8.5mm drill bit through rear
fixing holes on the Easy Slide base plate.
Feed the supplied M8 mounting plate through the drilled holes from the underside of the drawer top and
tighten using M8 Nyloc nut and washer. With the rear of the Easy Slide secured, fully extend the tray
assembly and repeat the mounting process at front fixing holes on the Easy Slide base plate.
Vacuum all swarf and the Easy Slide is now ready for use.
Installing and securing a fridge to the Easy Slide.
IMPORTANT
When fitting a fridge to the Easy Slide, always use quality tie-down straps and never travel with the fridge
unrestrained.
Lower the Easy Slide and place your fridge into the Easy Slide tray, ensuring best access to controls, power
socket and lid.
The Easy Slide has provisions for four tie-down straps, one in each corner of the fridge tray. An additional
strap bracket is included on the tray, should you choose to use this as a tie down point instead.
To secure fridge, hold the strap by the buckle above the Easy Slide and feed the loose end of the strap down
through the fridge handle/tie down point and through the Easy Slide strap provision from inside to out. Then
thread the loose end of the strap through the cam buckle from behind, keep pulling the strap through and in
a downward direction while holding cam buckle to tighten strap. Repeat this process on remaining tie down
straps.
For rear tie down straps, ensure the buckles are facing inwards (towards the fridge) to avoid creating a
"catch point" that may inhibit vertical movement of the Easy Slide.
Page | 5
Due to Clearview Continuous Improvement Program, information may change without notice.
Clearview takes no responsibility for the result of incorrect use of these installation instructions.