ClearView RT-RT110 Руководство по установке - Страница 18

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары ClearView RT-RT110. ClearView RT-RT110 20 страниц.

Печатать страницу
HOW TO INSTALL ROCK TAMERS
MESH INSERTS 33.5" (850mm)
Image 1
Image 2
1.
Set width of rubber flaps to approximately 31.5" (800mm) between the first Flap Clamp Bolts
on each side (see Image 1).
2.
Remove the 2 Flap Clamp Bolts, replace them with 2 included bolts with thread facing away
from vehicle. Lock bolts into position using a nut, tighten to 30 in-lbs (see Image 3).
THAT HARDWARE SHOULD BE SAVED FOR FUTURE USE.
3.
Place the Mesh Insert on these bolts, mark the location of the hole and slot that will be cut
for the ball-mount on the Mesh Insert.
4.
With the Mesh Insert still in place, mark the location of the lower 2 eyelets on the rubber
flaps.
5.
Place the Mesh Insert on a scrap piece of wood and cut the hole and slot using a sharp blade.
(see dotted line in Image 2)
BETWEEN THE 2 TOP CENTRE EYELETS.
6.
Drill 1/4" (6mm) holes in the rubber flaps, corresponding with the markings from the lower
eyelets.
*NOTE THAT THE RUBBER FLAPS SHOULD BE PLACED ON A SCRAP PIECE OF
WOOD, ON A SOLID SURFACE.
7.
Insert a bolt, with 1 large washer, into the hole in the rubber flap with the thread facing away
from the vehicle.
8.
Place another large washer over the lower bolt, then lock the bolt into position using a nut
(see Image 4).
9.
Repeat steps 7 & 8 on the other rubber flap.
10.
Place the Mesh Insert over the 4 bolts and secure in place using 4 small washers, 4 split lock
washers and 4 wing nuts.
11.
Lace the 2 top centre eyelets together using zip tie or string (not included).
NOTE
Additional access slots can be cut for power leads, chains, etc.
The Mesh Insert is a disposable item and available for purchase from Clearview Accessories.
The life of the Mesh Insert will vary depending on road conditions and speed.
A loose-fitting mesh will last longer than a tight-fitting mesh.
18
*NOTE THAT THE SLOT, IF REQUIRED, SHOULD BE CUT
clearviewaccessories.com.au
Image 3
Image 4
*NOTE