Altrason Humidry BRA-200V Руководство по установке - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке для Осушитель Altrason Humidry BRA-200V. Altrason Humidry BRA-200V 13 страниц. Ceiling mounted desiccant rotor multifunctional dehumidifier

Печатать страницу

Preparing the

ceiling hole

Preparing the ceiling hole

・

Prepare a ceiling hole in the bath room

measuring 450x350mm. Caution:

Provide at least 20cm of spacing between the wall

and the air intake for removing and installing the

filter.

When installing near any doors, make sure there is

enough clearance provided so that the door does

not hit the unit.

350mm

・

Ceiling must be capable of handling the weight of the

unit (7.2kg) and compensated where necessary.

・

Make sure the thickness of the ceiling is no more than

40mm, as the unit cannot be fitted if the ceiling is over

this thickness.

Installing the unit

・ Connect one end of the RJ45 cable into the RJ45 jack

of the unit (The other end will connect with the Wall

Panel or the Infrared Receiver).

Installation Steps

Installing

Electrical

the unit

Work

450mm

Ceiling

strength

Compensation

Wall Panel

Infrared Receiver

Installation

・ Install a 4-inch (10cm) duct to the unit' s exhaust

duct connector.

・

Secure the duct with duct tape or clamps.

・

Adjust the exhaust duct accordingly and make

sure the duct is not pinched, as this will constrict

air flow.

・

It is recommended that a bird guard be used

with your exterior exhaust vent to prevent birds

and rain from entering.

・

Tilt the unit into the ceiling opening.

・ Use the supplied M4.0 x 31.75mm self-tapping

screws to secure the unit onto the ceiling.

M4.0 x 31.75mm

・ Use the supplied M4.0 x 12mm self-tapping

screws to attach the Bottom Cover to the unit.

M4.0 x 12mm

Operational

Testing

（Continued on next page）