Clearwell Mobility Admiral Mk3 Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Скутер Clearwell Mobility Admiral Mk3. Clearwell Mobility Admiral Mk3 16 страниц.

Hazards

Getting on and off the Vehicle

• When getting on, make sure that the vehicle is on level ground and not in freewheel

mode.

• Ensure that the armrests are secure.

• When getting off, park on level ground, turn off the ignition and remove the key

before leaving your seat.

Tiller Position

• Never drive with the tiller in the unlocked position, as injury could result from

unintended tiller movement whilst driving.

Kerbs and Obstacles

• Do not ride up kerbs or obstructions higher than that in the Technical Specification

Sheets.

• Always tackle kerbs and obstacles head on.

• The anti-tip rollers at the rear of the scooter may contact the kerb as you descend,

this may cause a noise, which is normal.

• Take great care to avoid tipping.

• Never make sharp turns on slopes.

Try to avoid crossing slopes - always try to drive straight up and down the slope -

never reverse down a slope.

Going Up a Hill

• Lean forward when going up hill.

• Make sure you have enough speed to climb the slope.

• Do not stop or turn the vehicle around.

• If you have to turn whilst going up an incline keep going until you reach a level area.

• If you have to start on an incline, lean forward and apply power slowly.

• Consider adjusting your seat forward if you're not comfortable with the gradient.

Going down a hill

• When going down a hill lean back in the seat, and turn the speed control dial to low.

• If you are not comfortable with the hill gradient, consider adjusting your seat position

further back.

Ramps

• When using a ramp for access, please ensure that it is capable of taking the combined

weight of the scooter and yourself.

• When a ramp is being used, please ensure that the ramp is stable and properly

secured.

Lap Belt

• Pull the buckle over your lap and push firmly into the receiver. Ensure that there is no

excess belt material and the belt is tensioned correctly.

• To release the belt, push the red button marked 'PRESS' .