Edic CR2 Руководство пользователя/оператора - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя/оператора для Оборудование для уборки Edic CR2. Edic CR2 19 страниц. Professional restroom cleaner
Также для Edic CR2: Руководство по эксплуатации (9 страниц)
Печатать страницуMAINTENANCE:
This CR2 has been engineered and built to require mini-
mum maintenance. But like any machine, it does require
some care to keep it in optimum working condition.
Careful attention to these maintenance instructions will
give you maximum operating performance and life ex-
pectancy of the machine.
CAUTION: Disconnect the power cord from the outlet
before doing any clean up or maintenance on the ma-
chine
1. Keep the machine clean. Do not allow dust to accu-
mulate on external surfaces or near any moving parts.
2. After every job, wipe down the surface of the ma-
chine with a clean damp cloth.
3. Inspect cord for damage. Do not use machine with a
damaged cord.
PERIODIC MAINTENANCE
•
Use only chemicals safe for extractors
•
Adhere to the appropriate mix ratios for all chemicals
•
Do not add chemical to the solution tank- use the
chemical feed system or prespray
•
For optimal performance, it is suggested that the
operator flush the system after every job or at the end
of the day.
•
Pump seals and valves may need to be replaced at the
1000 hour mark if a loss in pressure is noted
•
The pressure regulator may require servicing should a
pressure drop be noted
Daily:
•
Flush chemical lines with water by placing clean wa-
ter in the soulution tank and using the pump to spray.
•
Check and clean vacuum filter
Weekly:
•
Check and clean solution filter
•
Check for obstructions in vacuum pathways
•
Quarterly:
•
Check pump, plumbing and fittings for leaks
•
Check power cords and hoses for tears
CORD STORAGE:
While not in use, storage can be accomplished by wind-
ing cord around accessory racks. Cord should be
completely unwound during operation.
CORD SAFETY
•
Do not leave appliance when plugged in. Unplug
from outlet when not in use and before servicing
•
Do not use with damaged cord or plug. If appliance is
not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return to service
center for inspection and repair.
•
Do not pull or carry by cord, use cord as handle, close
a door on cord, or pull cord around sharp edges or
corners. Do not run this CR2 over cord. Keep cord
away from heated surfaces.
•
Do not unplug by pulling cord. To unplug, grasp the
plug, not the cord.
•
Do not handle plug or appliance with wet hands.
•
This equipment should be stored indoors and not
exposed to rain.
6