Altronic A 1011 Инструкция по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Инструкция по эксплуатации для Пульт дистанционного управления Altronic A 1011. Altronic A 1011 4 страницы. Two channel uhf remote control switch system
Печатать страницу
Learning Mode: Programming:
NOTE: The radio control units included in the pack are already programmed and
ready to use.
See the above diagram to nd the correct buttons to press.
Press the P1 as instructed below to enter different modes:
ONE time to program R1 in monostable mode - LED ashes one time and stays
alight, then press the button that you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The control mode of relay is
non-locking (state A).
TWO times to program R2 in monostable mode - LED ashes two times and stays
alight, then press the button that you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The control mode of relay is
non-locking (state B).
THREE times to program R1 in bistable mode - LED ash three times and stays
alight, then press the button that you want the unit to learn, until the LED goes off.
Channel R1 has successfully learned the code. The control mode of relay is
interlocking (state C).
FOUR times to program R2 in bistable mode - LED ash four times and stays alight,
then press the button that you want the unit to learn, until the LED goes off.
Channel R2 has successfully learned the code. The control mode of relay is
interlocking (state D).
Note: If you press P1 many times, the state D will deactivate. Hold down the key of
the radio remote control that you would like to acquire until the led blinks.